Hi Karl, I hope this message finds you well. May I please request you to add a feature in RAM Concept where we can model the carbon strip laminates to the soffit of the slab and check the change in the slab capacity and the quantity of CFRP requir...

Enhancement submitted on behalf of John Gruber. CS0134441 - PBI PRODUCT BACKLOG ITEM 1526907: NDS Cr values for assemblies. My member I was analyzing is 4-2x12. Therefore, there are four 2” nominal thickness members and are more than three members...

Could we get the option for other than rectangular openings in shells? Round openings in particular would be very helpful, especially in an FEA program where sharp corners create large stress concentrations that may not even be present when many o...

Implementation of ACI 318-14 code in concrete design for anchor design in Ram connection (In Design of Base Plate) due to client However, the software tool supports only for the code ACI 318-08 , ACI 318-11 and ACI 318-19 . Need STAAD Version whic...

I would like to request that you make an option available to make the units for the bar presentation different from the units that I work with in plan. I tend to work with inches when I am adjusting the geometries of slabs and bars because working...

Add connection type - 'Toe Plates'. Commonly used on site to provide a moment connection between cross-beams. Add connection type - 'Base Plate - Column on Beam Top Flange' Add feature to allow gusset plate lengths at beam interface to be modified...

This provision is useful in PEB buildings where all structural members are formed by using built-up plates. By using this option, we can avoid supplementary web plates uses in connections.

Enhancement submitted on behalf of Conor Daly, from Jacobs Engineering Group. CS0223518 – PBI PRODUCT BACKLOG ITEM 1453001: I would like to request an option to manually adjust the width of the gusset. Right now, you can see in the attached that t...

Enhancement submitted on behalf of Taye Ojo, from Jacobs Engineering Group. CS0222072 – PBI PRODUCT BACKLOG ITEM 1509265: Is there a way to include in the stresses that are compared vs 0.2F´c for the check of section 18.10.6.3.