To request the integration of the AIJ(Architectural Institue of Japan) design standards into RAM Connection to support connection design compliant with Japanese building code requirements. Other Bentley products are also being used in Japan. Integ...

Weld group only calculates fillet welds. Seems like a simple addition to check partial penetration groove, flare bevel, and other welds.

I believe it would be beneficial to incorporate stiffeners into skewed angled shear connections to enhance their strength and stability. Implementing this adjustment could improve performance and overall structural integrity.

I am currently designing a horizontal column-beam-brace connection where one beam is a W12 section and the other is a W8 section. I would like to design the gusset plate using a bolted flange connection. However, I have noticed that the software c...

It is especially needed for copped beams to the web of W columns connections with extended end plates.

Double back-to-back channels are typical for design of walers. Adding double channel section for beam splice connection with end plates would allow for this type of connection to be modeled.

Currently, there are relatively few stiffening rib arrangements that can be selected in RAM. There is currently no way to customize the arrangement of stiffening ribs in the software. This brings inconvenience to project execution. It is hoped tha...

I had a connection that required a shear connection framing from one beam, a moment connection from another beam and a horizontal brace from another beam all at one column. The detailer needed a combined detail merged as one. As another example, w...

There seems to be a small number of modules that actually use the "opposite beam exists" checkbox, however most don't seem to be impacted by it. For connections that don't use it, the option should either be removed, or the module should be update...