Referring to Fig. R17.7.2.1a & Fig. R17.11.3.1 from ACI318-19 (refer attached sketch), these are the two similar concrete breakout failures one in case of Anchor bolts (case 1) and other for shear lug (case 2). In both cases, concrete breakout...

In this version, each joints are designed after they are selected as per each type but too many case should be designed manually. Interface of RAM is great but it takes much time to input all the data of joints. Suggested as below; 1. Joint grou...

It is already widely used

Design Guide 1 allows for the use of oversized holes with washers that are welded (or not welded) for installation purposes. It would be nice to be able to have an option that would you could select that would include geometric checks.

99% of the details I have seen for vertical x-bracing shows one member continuous. I design a lot of connections for a steel fabricator and I am always required to perform a hand calc or 2 ram connection calcs with one being the horizontal X-brace...

Please Incorporate the Splice Connections consider the seismic provisions from AISC 341-10 codes in RAM connection software. This will be very useful for High seismic zone.

Currently, there is no way to design a gusset base plate connection if the column base has braces coming into it from 2 different planes. You can't even assign 2 separate connections, one for each plane, like you can at CBB joints.

This will save time when checking typical base plate locations and identify when model/load changes affect the base plate acceptability.

There doesn't seem to be a way (at least not obvious) to add custom shapes and materials in the STAAD built-in Ram Connection. So if you have a custom connection like this then you must use the stand-alone. This is frustrating when you are using s...